The Future For Solid State Technology On Server Motherboards

from the memories,-like-the-corners-of-my-mind dept

Mon, Nov 30th 2009 3:05pm — ITInnovation

For the past several months, the possibilities of solid state technology have been explored for all sorts of applications. Some observers note that solid state technology inside the server are on the way, but others point out that solid state technology might still be too expensive for typical server applications. As the costs inevitably come down, though, the more important questions might be more along the lines of "where should solid state technology be located to maximize ROI?" or "how can solid state technology be used most effectively?" The use of solid state technology in a variety of new configurations will ultimately depend on the cost effectiveness of the applications, but the potential of 1 million IOPs in the performance of a single server over storage racks filled with thousands of hard drives could be getting a lot harder to pass up.

Thank you for reading this Techdirt post. With so many things competing for everyone’s attention these days, we really appreciate you giving us your time. We work hard every day to put quality content out there for our community.

Techdirt is one of the few remaining truly independent media outlets. We do not have a giant corporation behind us, and we rely heavily on our community to support us, in an age when advertisers are increasingly uninterested in sponsoring small, independent sites — especially a site like ours that is unwilling to pull punches in its reporting and analysis.

While other websites have resorted to paywalls, registration requirements, and increasingly annoying/intrusive advertising, we have always kept Techdirt open and available to anyone. But in order to continue doing so, we need your support. We offer a variety of ways for our readers to support us, from direct donations to special subscriptions and cool merchandise — and every little bit helps. Thank you.

–The Techdirt Team

4 Comments

If you liked this post, you may also be interested in...

Reader Comments

Subscribe: RSS

View by: Time | Thread

Greg O'Keefe - Intel (profile), 2 Dec 2009 @ 10:01am

Different types of solid state techology available for servers today
There are many different solid state (flash) technlogies being introduced into the market today. If you aren't familar with the Intel X25-E Extreme SATA Solid-State Drives (SSD), I'd recommend you evaluating them for your data center deployments for hybrid storage pools. This is a huge change from existing HDD technology.

Intel SSDs are available in every Sun server based on Intel Xeon processor. www.sun.com/intel
[ link to this | view in chronology ]
Devin Moore (profile), 7 Dec 2009 @ 2:41pm

no moving parts
IMHO, the true savings of solid-state would be in the lack of moving parts that could fail vs. some speed increase. If a robust solid-state HDD, power supply, etc. could be built so that the pc had absolutely no moving parts, that should yield a much longer shelf life, meaning a much lower total cost of ownership if you have 100,000 of them in a datacenter, right?
[ link to this | view in chronology ]
- Mac McConnell (profile), 8 Dec 2009 @ 10:16am
  
  Re: no moving parts
  Devin, you are correct. Beyond the risk of mechanical failure being near zero, Solid-state drives also provide improved overall system responsiveness while consuming much less power than a traditional hard disk drive. This translates into a cooler, quieter platform.
  
  Mac McConnell from Sun Microsystems.
  [ link to this | view in chronology ]
- Greg O'Keefe - Intel (profile), 8 Dec 2009 @ 10:33pm
  
  Re: no moving parts
  Devin - Solid-State Drives provide more value than just the fact that they don't have moving parts like HDDs for higher reliability. That is only the starting poitns - there are additional points such as improved energy efficiency, faster performance and lower costs per IOPs than HDDs.
  
  Greg O'Keefe - Intel
  [ link to this | view in chronology ]