DailyDirt: High Performance Vehicles Without Internal Combustion Engines
from the urls-we-dig-up dept
Racing cars is supposed to lead to technologies that eventually end up in consumer vehicles. So if that's the case, there should be a lot more electric car races on the way, right? Well, there are... But the performance of electric cars isn't always awe-inspiring (except for straight-line drag racing, perhaps).- The European Union is talking about starting a Formula One racing event for electric vehicles. It could begin in 2013 if everything runs smoothly. [url]
- Peugeot set a production electric car record at the Nürburgring track -- finishing a lap in about 9 minutes. Too bad that translates to a somewhat unimpressive average speed of 86 mph, though... [url]
- All-electric cars usually suffer from limited range (compared to hydrocarbon-burning vehicles), but putting motors in the wheels eliminates drivetrains and other components -- which could produce electric cars with more practical recharging requirements. The Japanese SIM-LEI vehicle uses the same batteries from Toyota and gets a 200 mile range, which might help to end "range anxiety" for EV drivers. [url]
- The National Electric Drag Racing Association (NEDRA) promotes all kinds of electric vehicle performance competitions. Instant torque is a nice feature for electric motors, apparently. [url]
- To discover more interesting car-related content, check out what's driving around StumbleUpon. [url]
Thank you for reading this Techdirt post. With so many things competing for everyone’s attention these days, we really appreciate you giving us your time. We work hard every day to put quality content out there for our community.
Techdirt is one of the few remaining truly independent media outlets. We do not have a giant corporation behind us, and we rely heavily on our community to support us, in an age when advertisers are increasingly uninterested in sponsoring small, independent sites — especially a site like ours that is unwilling to pull punches in its reporting and analysis.
While other websites have resorted to paywalls, registration requirements, and increasingly annoying/intrusive advertising, we have always kept Techdirt open and available to anyone. But in order to continue doing so, we need your support. We offer a variety of ways for our readers to support us, from direct donations to special subscriptions and cool merchandise — and every little bit helps. Thank you.
–The Techdirt Team
Filed Under: electric vehicles, f1, racing, range anxiety
Companies: nedra, peugeot, toyota
Reader Comments
Subscribe: RSS
View by: Time | Thread
Electric McRae Buggy for the 2012 Dakar Rally
[ link to this | view in thread ]
Assumptions
[ link to this | view in thread ]
Got to get away from burning dead things for energy.
And where abouts on the roads can you drive at 86 MPH ?
I believe the national US speed limit is 55 mph, is that correct ?
From maths, I think (citation needed) that 86 mph is HIGHER than 55 mph. ;)
• All-electric cars usually suffer from limited range (compared to hydrocarbon-burning vehicles),
ALL cars USUALLY !!!!!!! great engligh !!
Motors in hugs reduces frictional losses, that would apply equally well to IC (internal combustion) engines.
If you reduce friction losses, you increase range.
Petrol cars also have VERY limited range, have you ever noticed how many servo's there are when you go out ???
That is because cars consume vast amounts of fuel.
And the energy content in fuel is higher than the energy content in the equavelent weight of batteries.
But electric motors can be built with 98% efficiency, whereas the IC motor has a maximum possible efficiency of 56%, and rarly goes about about 25% efficiency.
So if you can store the same energy value in batteries as you can in the equivalent weight of fuel (petrol), ie energy density the same.
Then an electric car would have a range of 3 to 5 times that of an equavelent petrol powered vehicle.
The latest generate of LiPo batteries (Lithium-ion polymer) batteries have a energy density value comparable or greater than the same weight in petrol, or deisel.
Once those batters come done in price, and receive more development, IC engines with their 25-30% eff at best will be blown away by electric equivalents with their 98% efficient motors and batteries.
Only trouble is most of your electricity in the US is derived from coal. So you lose a great deal of 'system' efficiency by using an inefficient power generation system to charge your batteries.
that still means you are running on fossel fuel.
Nuclear, and the development of fusion power will save the earth...
We are such a primitive race that so far we have not evolved from burning things we pick up off the ground for our energy source !!!!
Just as the cave men did.... now that's progress.
[ link to this | view in thread ]
Re: Assumptions
[ link to this | view in thread ]
Re: Got to get away from burning dead things for energy.
German autobahns (where the Nurburgring is).
Ever wondered why the German car industry is so successful? Well part of it is down to the existence of de-restricted roads in that country.
[ link to this | view in thread ]
in wheel motors
Un-sprung weights make the car unresponsive, and handle poorly. http://en.wikipedia.org/wiki/Unsprung_mass for more reading on it.
[ link to this | view in thread ]
Electric cars
So, using that analogy, autos were doomed, right? Wonder why they are still here; or why eventually all vehicles will be powered by other than fossil fuels (probably electric)?
[ link to this | view in thread ]
Re: Got to get away from burning dead things for energy.
[ link to this | view in thread ]
Re: Ever wondered why the German car industry is so successful?
Cue quick re-rationalization in 3 ... 2 ... 1 ...
[ link to this | view in thread ]
Re: Electric cars
Yes, but they pirated all the goods and passenger traffic that rightfully belonged to the horse-drawn transport, and that’s how they became successful! The enginetards stole all that equine-tellectual property!
[ link to this | view in thread ]
Re: Re: Got to get away from burning dead things for energy.
and not all cars on the planet run on the autobahn either.
If fact MOST do not.
[ link to this | view in thread ]
Re: in wheel motors
But just replacing the 100 Hp petrol motor that is 25% efficient (actually consuming 400 hp to produce that 100 hp).
with a 98% efficient DC brushless motor that consumes 102 hp to generate 100 shaft HP, then you have blown away the range and performance/efficiency of the vehicle.
So a simple engineering problem of 'unsprung mass' might be enough to stop you in your 'tracks', but it seems it is not an issue in the real world.
Not to mention there are allready electric cars with hub motors, so saying it cant be done is quite odd, seems it is routinely done.. Just may be not by you..
But to state we 'cant do something, because of a simple technical issue' therefore we will continue to burn fossel fuels is why we are where we presently are.
The ONLY reason we use fossel fuels at present is because we are lazy F&^%s and dont give a shit about the future.
And would rather spend money on war and killing than investing money in a clean and secure energy source.
If petrol and deisel were banned from sale for cars and trucks, then within 6 months the market would be filled with effective, efficient and very usefull electric vehicles along with the required infrastructure to support them.
The only reason that is not happening is because we are cheap and lazy.
[ link to this | view in thread ]
Unsprung weight - solved.
Eliminating mechanical transmission inc. gearboxes, differentials, drive shafts and axles provides a significant weight and manufacturing cost saving, while also decreasing the environmental impact of the product.
[edit] Unsprung weight
A design consideration with wheel motors is unsprung weight. Most conventional electric motors include ferrous material composed of laminated electrical steel. This ferrous material contributes most of the weight of electric motors. As excessive unsprung weight can lead to less than optimal vehicle handling, several recent wheel motor designs have minimized the electrical steel content of the motor by utilizing a coreless design with Litz wire coil windings to reduce eddy current losses. This significantly reduces wheel motor weight and therefore unsprung weight.
Another method used is to replace the cast iron friction brake assembly with a wheel motor assembly of similar weight. This results in no net gain in unsprung weight and a car capable of braking up to 1G. [11] A good example of this is the Michelin Active Wheel motor as fitted to the Heuliez Will that results in an unsprung weight of 35 kg on the front axle which compares favorably to a small car such as a Renault Clio that has 38 kg of unsprung weight on its front axle. [12]
http://en.wikipedia.org/wiki/Hub_motor
[ link to this | view in thread ]
Re: Got to get away from burning dead things for energy.
[ link to this | view in thread ]
You keep making a fool of yourself.
There is only one significant difference between the Nürburgring and the regular autobahn: it is a toll road. It is still a highway without a speed limit.
Additionally, there is no reason why the vast majority of cars that are operated regularly today are not driven on the autobahn or the Nürburgring.
[ link to this | view in thread ]
Re: Re: in wheel motors
This is the height ridiculousness. Trains are very well known for having extremely poor acceleration and deceleration and are literally unable to go around a corner and can only follow carefully planned straight lines and only if necessary, an extremely wide turning radius.
Additionally, motor-in-hub designs are nowhere near perfect, or even competitive. They are expensive, weak, and provide inferior braking performance in comparison to common disc brakes.
You don't seem to understand that the main reason people don't buy entry level EVs is this: they are slow, heavy, expensive, unreliable, boring, miserable piles of shit.
The very, very few EVs that break out of this mold are so hilariously expensive that it's trivial to pick another vastly superior vehicle for much less money.
[ link to this | view in thread ]
National speed limit
[ link to this | view in thread ]
Re: Re: in wheel motors
If you think a vehicle that travels on rails is 'responsive', then you quite clearly don't know what responsive means in the context of vehicles. I am concerned for cynic within you - you seem to have a remarkably strong opinion for somebody who has done little enough fact-checking to spot this (IMHO) glaring error.
[ link to this | view in thread ]
Re: You keep making a fool of yourself.
Minor niggle: they have a couple of places where there is a speed limit on days where the track is open to the public. A few of the more blind/twisty/evil-camber type bits that would be unacceptably dangerous for the average road driver to choose their own speed for... but in general, yes, it's just a toll road that goes back to where it started. You can only still be prosecuted for passing on the right, for example.
[ link to this | view in thread ]
Re: Got to get away from burning dead things for energy.
just a minor note here... the original was "All-electric cars usually" -- meaning "all-electric" as opposed to "partial-" or "hybrid-" electric cars. (That hyphen actually has a purpose...)
[ link to this | view in thread ]
Re: Re: Ever wondered why the German car industry is so successful?
The Japanese have cornered the utility market (where the unrestricted roads don't matter) but Germany rules the high end...
[ link to this | view in thread ]
Re: Name the Japanese cars that compete successfully with high performance German cars like Audi, BMW, Mercedes and Porsche.
[ link to this | view in thread ]